3D Scanner: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
(Nieuwe pagina aangemaakt met 'Category:CNCCategory:SafetySheetCategory:ToolCategory:ManualCategory:Notes = Work in progress = We have a 3D scanner based on a Microsoft XBox...')
 
(Ownership)
Regel 17: Regel 17:
 
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie {{OnLoan}} and to be '''kept at the makerspace''' at all times. No exceptions.
 
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie {{OnLoan}} and to be '''kept at the makerspace''' at all times. No exceptions.
  
{{SafetyCat3}}  
+
{{SafetyCat5}}  
 
{{NoiseCat3}}
 
{{NoiseCat3}}

Versie van 16 nov 2019 om 23:08


Work in progress

We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Snanect] software and a Mac Mini.

Instructions for use

  • Log in as Guest
  • Start the Scanect Software
  • Configure for a BOX scan (1x1 is about righ).
  • Go through each of the steps.
  • Save the resulting file (PLY) to a USB disk

Ownership

The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie Sjabloon:OnLoan and to be kept at the makerspace at all times. No exceptions.

This equipment is safety category 5: Equipment that is relatively fragile or expensive

  • In person instructions is not mandatory.
  • Reading the wiki, and following the instructions, is mandatory.

This equipment is Noise Category 3: Can be used at all hours. No limits.