3D Scanner: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
(Ownership)
Regel 17: Regel 17:
 
== Ownership ==
 
== Ownership ==
  
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie {{OnLoan}} and to be '''kept at the makerspace''' at all times. No exceptions.
+
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie {[[Category:OnLoan]]) and to be '''kept at the makerspace''' at all times. No exceptions.
  
 
== Usage ==
 
== Usage ==

Versie van 16 nov 2019 om 23:16


XX replace by something taken in the space !

Work in progress

We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Snanect] software and a Mac Mini.

Instructions for use

  • Log in as Guest
  • Start the Scanect Software
  • Configure for a BOX scan (1x1 is about righ).
  • Go through each of the steps.
  • Save the resulting file (PLY) to a USB disk

Ownership

The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie {) and to be kept at the makerspace at all times. No exceptions.

Usage

This equipment is safety category 5: Equipment that is relatively fragile or expensive

  • In person instructions is not mandatory.
  • Reading the wiki, and following the instructions, is mandatory.

This equipment is Noise Category 3: Can be used at all hours. No limits.