3D Scanner: verschil tussen versies
(→Reinstall from 'zero') |
(→Reinstall from 'zero') |
||
| Regel 17: | Regel 17: | ||
== Reinstall from 'zero' == | == Reinstall from 'zero' == | ||
| − | See [3D Scanner - installation notes] for more information. | + | See [[3D Scanner - installation notes]] for more information. |
== Ownership == | == Ownership == | ||
Versie van 17 nov 2019 om 16:09
Work in progress
We have a 3D scanner based on a Microsoft XBox Kinekt device, the [Skanect] software and a Mac Mini.
Instructions for use
- Log in as Guest
- Start the Scanect Software
- Configure for a BOX scan (1x1 is about righ).
- Go through each of the steps.
- Save the resulting file (PLY) to a USB disk or SD card (slot is on the back, left hand side)
Reinstall from 'zero'
See 3D Scanner - installation notes for more information.
Ownership
The Mac Mini, Kinekt and PSU are owned by Dirk-Willem van Gulik (zie Category:OnLoan) and to be kept at the makerspace at all times. No exceptions.
Usage
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
This equipment is Noise Category 3: Can be used at all hours. No limits.
