ER 25/32/40 Collets and holders: verschil tussen versies
| Regel 1: | Regel 1: | ||
[[Category:Tool]][[Category:Metal]][[Category:SafetySheet]] | [[Category:Tool]][[Category:Metal]][[Category:SafetySheet]] | ||
| − | |||
| − | |||
[[Bestand:Er25-set.jpeg|miniatuur|ER25 metric collet set]] | [[Bestand:Er25-set.jpeg|miniatuur|ER25 metric collet set]] | ||
| Regel 12: | Regel 10: | ||
Bought June 2019. | Bought June 2019. | ||
| + | |||
| + | == Rules == | ||
| + | {{SafetyCat5}} | ||
| + | {{NoiseCat3}} | ||
Versie van 4 jun 2019 om 14:17
Set of METRIC collets -- for the ER25 holder of the Abene, Metal Lathe and Wood Lathe. Sizes 1mm - 16mm -- and each will take 1mm smaller. So actual range is 0 to 16mm. Do not use them outside this range. They will break (check the box with the boring bar for examples).
Make sure you `angle-click' the collet into the nut (do not force it straight). Have someone show you if you've not done it before -- as it is easy to get them out of shape this way -- causing vibration.
History
Bought June 2019.
Rules
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
This equipment is Noise Category 3: Can be used at all hours. No limits.
