Difference between revisions of "Hembrug DrillPress BoorKolom PillarDrill"
DirkWillem (talk | contribs) (→Safety Relay, Stop button) |
DirkWillem (talk | contribs) (→Motor) |
||
| Line 17: | Line 17: | ||
== Motor == | == Motor == | ||
| − | Likely dalander switched. | + | Likely dalander switched. We do not have a NC on the 'off' to prevent start when on. |
[[Bestand:Dalander1.png|400px]] | [[Bestand:Dalander1.png|400px]] | ||
[[Bestand:Dalander2.png|400px]] | [[Bestand:Dalander2.png|400px]] | ||
Revision as of 22:08, 24 October 2021
This equipment is safety category 4:
- In-person, instructions strongly advised but not mandatory.
- Reading, and following, the instructions on the Wiki is mandatory!
This equipment is Noise Category 2:
Can be used at all hours, but in moderation.
Be considerate; if you feel you need to wear ear protection,
then only use the tool between 07:00 and 19:00.
Page about the changes/setup of the Hembrug pillar dril.
Safety Relay, Stop button
A safety relay was added; with a 4-6 amp current limiters along with an emergency stop button. Normal ground/earth wiring was added.
The current rotary switch does NOT allow for a switch-on block when in the wrong position. We need to find a replacement switch.
Motor
Likely dalander switched. We do not have a NC on the 'off' to prevent start when on.
