Hembrug DrillPress BoorKolom PillarDrill: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
(Safety Relay, Stop button)
(Safety Relay, Stop button)
Regel 9: Regel 9:
 
== Safety Relay, Stop button ==  
 
== Safety Relay, Stop button ==  
  
A safety relay was added; with a 4-6 amp current limiters along with a stop button.
+
A safety relay was added; with a 4-6 amp current limiters along with an emergency stop button. Normal ground/earth wiring was added.
  
 
The current rotary switch does '''NOT''' allow for a switch-on block when in the wrong position. We need to find a replacement switch.
 
The current rotary switch does '''NOT''' allow for a switch-on block when in the wrong position. We need to find a replacement switch.

Versie van 24 okt 2021 om 22:07

This equipment is safety category 4:

  • In-person, instructions strongly advised but not mandatory.
  • Reading, and following, the instructions on the Wiki is mandatory!

This equipment is Noise Category 2:
Can be used at all hours, but in moderation.
Be considerate; if you feel you need to wear ear protection,
then only use the tool between 07:00 and 19:00.

safety sheet drill press

Page about the changes/setup of the Hembrug pillar dril.

Safety Relay, Stop button

A safety relay was added; with a 4-6 amp current limiters along with an emergency stop button. Normal ground/earth wiring was added.

The current rotary switch does NOT allow for a switch-on block when in the wrong position. We need to find a replacement switch.

300pk

Motor

Likely dalander switched.

Dalander1.png Dalander2.png