Router Table / Tafelfrees: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
Regel 1: Regel 1:
 
[[Category:SafetySheet]][[Category:Tool]][[Category:Wood]][[Category:Metal]]{{SafetyCat3}}{{NoiseCat2}}{{DustControl2}}[[Category:OnLoan]]
 
[[Category:SafetySheet]][[Category:Tool]][[Category:Wood]][[Category:Metal]]{{SafetyCat3}}{{NoiseCat2}}{{DustControl2}}[[Category:OnLoan]]
 
[[Bestand:Tablerouter.jpeg|miniatuur]]
 
[[Bestand:Tablerouter.jpeg|miniatuur]]
 +
 
Router Table.
 
Router Table.
  
 
'''WARNING: has an imperial collet !'''
 
'''WARNING: has an imperial collet !'''
 +
 +
{{Imperial}
  
 
Be very careful with the collet sizes; a 1/4 of an inch is almost 6mm - but not quite.  Putting a 6mm bit into a 1/4th of an inch collet will absolotely ruin it. And they are expensive and hard to replace (long lead team; 30-60 euro's).
 
Be very careful with the collet sizes; a 1/4 of an inch is almost 6mm - but not quite.  Putting a 6mm bit into a 1/4th of an inch collet will absolotely ruin it. And they are expensive and hard to replace (long lead team; 30-60 euro's).

Versie van 6 jun 2019 om 12:44

This equipment is safety category 3:

  • Mandatory, in person, instructions.
  • Make sure you read the Wiki before asking.

This equipment is Noise Category 2:
Can be used at all hours, but in moderation.
Be considerate; if you feel you need to wear ear protection,
then only use the tool between 07:00 and 19:00.

This equipment is should be used with active dust control.
Connect the shopvac prior to use.

Tablerouter.jpeg

Router Table.

WARNING: has an imperial collet !

{{Imperial}

Be very careful with the collet sizes; a 1/4 of an inch is almost 6mm - but not quite. Putting a 6mm bit into a 1/4th of an inch collet will absolotely ruin it. And they are expensive and hard to replace (long lead team; 30-60 euro's).

Ownership

Owned by HansD. See Category:OnLoan.