SimpleBoxMaking

Uit MakerSpace Leiden
Versie door DirkWillem (overleg | bijdragen) op 12 jan 2019 om 20:29 (Nieuwe pagina aangemaakt met 'Category:Docu Simple box making (notes to stop myself from re-inventing this) # Find a rectangular piece of plywood # Measure width - divide by 3 (this will...')
(wijz) ← Oudere versie | Huidige versie (wijz) | Nieuwere versie → (wijz)
Ga naar: navigatie, zoeken


Simple box making (notes to stop myself from re-inventing this)

  1. Find a rectangular piece of plywood
  1. Measure width - divide by 3 (this will be the -height- of the box)
  1. Set this width on the table saw (clean with)
  1. Saw length wise. So the last strip will in fact be smaller than the first two.
  1. Cut, from each strip; one piece the length of the box (back to back). Generally you can do this twice; for two boxes.
  1. Cut from the two wider strips; two square pieces. Generally you can do this twice; for two boxes.
  1. Adjust the height of the tablesaw to half the tickness of the plywood. Adjust the distance to be half as wel.
  1. Make the flat cuts and the perpendicular cuts.
  1. Finally, if needed - adjust the width of the bottom piece.