Brontekst bekijken van Node Lights Out

[[Category:ACNode]][[Category:RunningTheSpaceDocs]]

[[Bestand:NodeLightsOut-outside.jpg|miniatuur|Lichten node/verklikker (photo out of date)]]

[[https://www.olimex.com/Products/IoT/ESP32/ESP32-POE/open-source-hardware OLIMEX PoE]] gebaseerde node die kijkt naar de 3 AC netten van het licht. 

= Wiring and technical data =

The 6 screw terminals are Optocoupler detect (2x3) of AC.

All 3 expect AC/230 volt. The RED led on the front is the 'AartLED'.

Code in [[https://github.com/dirkx/AccesSystem/blob/master/lib-arduino/ACNode/examples/LightsOutNode/LightsOutNode.ino]]/

Current mac address is '''3C:71:BF:10:62:A7''' -- wired to the top patch panel, port 23.  It is currently connected by a yellow cable to the top switch; port 23 (auto-negotiation, no further settings)

= Update September 2019 =

The AC voltage resistors/optocouplers have been moved out of the low voltage electronics box; and now reside in/behind the two light switches. With just 2 and 4 wires (gnd/E and signal/C of the optocouplers) going to the grey box. 

White is the gnd, the colours (brown, orange, green) are the signal wires.

Furthermore GPIO 34 (was 5) has been wired to a 433 Mhz receiver - for [[MainsSensor|our radio based mains-monitoring]]. As the digital out is 5volt - there is a simple 3k3/1k8 voltage divider to bring the signal to the 3v3 that the ESPs GPIO likes.

= Building wiring =

Note that the building wiring is a bit funny - an earth wire is used as a black-switch phase wire in the leftmost switch. Talk ''first'' to the trustees if you want to fix it - as this is a key part of building relative to the agreements made with the landlord.

= Opto electronics =

[[Bestand:Opto-wiring.png|400px|Wiring of the 3 opto couplers]]

= Typical log =

AC1 to AC3 are the OPTO couplers state; True is off (there is a pull up at work), False is AC voltage detected.

     {
       "node": "lights",
       "machine": "lights",
       "maxMqtt": 768,
       "id": "a46210bf713c",
       "ip": "192.168.3.173",
       "net": "UTP",
       "mac": "3C:71:BF:10:62:A7",
       "beat": 0,
       "approve": 0,
       "deny": 0,
       "requests": 0,
       "cache_hit": 0,
       "cache_miss": 0,
       "mqtt_reconnects": 1,
       "loop_rate": 11137.78,
       "coreTemp": 72.22222,
       "heap_free": 223272,
       "state": "Powered - no lights",
       "powered_time": 1195,
       "running_time": 0,
       "ota": true,
       "acstate1": true,
       "acstate2": true,
       "acstate3": true
    }