Jigs (wood): verschil tussen versies
| Regel 1: | Regel 1: | ||
| − | [[ | + | [[Cateorie:Wood]] |
| + | |||
This page regroups information about custom made jigs for various machines of the wood workshop. | This page regroups information about custom made jigs for various machines of the wood workshop. | ||
Versie van 8 apr 2024 om 10:44
This page regroups information about custom made jigs for various machines of the wood workshop.
Inhoud
Table Saw jigs
Rod maker (table saw lathe)
The purpose of this jig is to create straight, cylindrical rods of wood, between ~20mm and ~90mm diameter, up to 65 cm in length, i.e. longer than what you can do with the wood lathe.
Material preparation
Table saw preaparation
 Warning: |
In order to operate the jig, it is necessary to remove the riving knife of the table saw, located behind the saw blade. Do not use the table saw with anything else than the jig while the riving knife is not mounted, there is a high risk of injury otherwise.
This can be done with a 19mm wrench.
