Smartphone glass repair kit: verschil tussen versies
(Nieuwe pagina aangemaakt met '= Smartphone glass repair kit = This kit was successfully used on Samsung Galaxy s4 mini to replace the broken glass. Instructions can be found on youtube (e.g....') |
|||
| Regel 6: | Regel 6: | ||
Instructions can be found on youtube (e.g. [https://www.youtube.com/watch?v=2CZvv26-iZw this one for s4 mini] | Instructions can be found on youtube (e.g. [https://www.youtube.com/watch?v=2CZvv26-iZw this one for s4 mini] | ||
| − | == | + | == New glass == |
Repair kit (glass + tools) ordered [http://www.ebay.co.uk/itm/261761888158 here]. The tools are worthless, the sticker and glass are good. | Repair kit (glass + tools) ordered [http://www.ebay.co.uk/itm/261761888158 here]. The tools are worthless, the sticker and glass are good. | ||
| Regel 12: | Regel 12: | ||
* flexible steel pry tool, necessary to lift the glass at the start in order to get the wire underneath the glass | * flexible steel pry tool, necessary to lift the glass at the start in order to get the wire underneath the glass | ||
* wire to pull between the glass and the touch sensor | * wire to pull between the glass and the touch sensor | ||
| − | [[Bestand: | + | [[Bestand:Tools_in_action.png]] [[Bestand:Tools_smartphone.png]] [[Bestand:Toolbox_smartphone.png]] |
== Process == | == Process == | ||
| Regel 24: | Regel 24: | ||
* Place the new glass in, and you're done! | * Place the new glass in, and you're done! | ||
| + | |||
| + | == After you are done == | ||
| + | * Put all the tools back in the box, put the box back in its place | ||
* Leave your comments, or a +1, here | * Leave your comments, or a +1, here | ||
Versie van 16 mei 2017 om 13:51
Smartphone glass repair kit
This kit was successfully used on Samsung Galaxy s4 mini to replace the broken glass.
Instructions can be found on youtube (e.g. this one for s4 mini
New glass
Repair kit (glass + tools) ordered here. The tools are worthless, the sticker and glass are good.
DIY Tools
- flexible steel pry tool, necessary to lift the glass at the start in order to get the wire underneath the glass
- wire to pull between the glass and the touch sensor
Bestand:Tools in action.png Bestand:Tools smartphone.png Bestand:Toolbox smartphone.png
Process
- Take the battery out, re-close the back lid.
- Heat the glass to 80-100 Celsius (do not go above 100). Use the heat gun on lowest setting about 20cm above the phone. Check continuously at various spots with infrared thermometer.
- Follow the video.
- Use tissues with acetone to remove glue leftovers
- Attach the sticker: think twice which way it will go, which sticky layer to expose first, pay attention to the camera hole etc. If not all holes are present on the sticker - apply first, then cut out holes for sensors with sharp knife/tweezers. Make sure the middle button is in the middle.
NB: It maybe better to apply the sticker to the glass first
- Place the new glass in, and you're done!
After you are done
- Put all the tools back in the box, put the box back in its place
- Leave your comments, or a +1, here
