PowerNodeBlue-bringup: verschil tussen versies
(→Initial Bringup / checkout) |
|||
| Regel 14: | Regel 14: | ||
## Place solder bridges Vpwr, V5 to VPOE/VPOE5 in Source field | ## Place solder bridges Vpwr, V5 to VPOE/VPOE5 in Source field | ||
## Do not place the Vpwr/5V bridges in the PoE field - these should be better labeled: e.g. have an 'OFF' text added to them like the one just above. | ## Do not place the Vpwr/5V bridges in the PoE field - these should be better labeled: e.g. have an 'OFF' text added to them like the one just above. | ||
| + | ## Plug in PoE ethernet; check voltages: 5V, 3v3 and Vpwr==5V | ||
# ESP32 | # ESP32 | ||
## Solder in the ESP32 | ## Solder in the ESP32 | ||
| + | ## Unplug PoE ethernet; plug in USB; | ||
| + | ## Check 115200 baud visibility of ESP32 (press reset if needed) | ||
Versie van 4 feb 2025 om 14:40
15 units; 25/01/23 fab date.
Initial Bringup / checkout
Board 001:
- Checked soldering/board as is.
- Plug in USB-C
- Check 3v3 and 5v power; check red LED
- check detection driver
- PoE powering
- Place solder bridges Vpwr, V5 to VPOE/VPOE5 in Source field
- Do not place the Vpwr/5V bridges in the PoE field - these should be better labeled: e.g. have an 'OFF' text added to them like the one just above.
- Plug in PoE ethernet; check voltages: 5V, 3v3 and Vpwr==5V
- ESP32
- Solder in the ESP32
- Unplug PoE ethernet; plug in USB;
- Check 115200 baud visibility of ESP32 (press reset if needed)
Improvements
- Add the word 'OFF' to the labels of all bridges in the PoE field (and not just the top one)
