PowerNodeBlue-bringup: verschil tussen versies
(→Initial Bringup / checkout) |
|||
| Regel 18: | Regel 18: | ||
## Solder in the ESP32 | ## Solder in the ESP32 | ||
## Unplug PoE ethernet; plug in USB; | ## Unplug PoE ethernet; plug in USB; | ||
| − | ## Check 115200 baud visibility of ESP32 (press reset if needed) | + | ## Check 115200 baud visibility of ESP32 (press reset if needed). Should see <pre>ets Jul 29 2019 12:21:46 |
| + | rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) | ||
| + | configsip: 0, SPIWP:0xee | ||
| + | clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00</pre> | ||
| + | ## Check blink app. | ||
== Improvements == | == Improvements == | ||
# Add the word 'OFF' to the labels of all bridges in the PoE field (and not just the top one) | # Add the word 'OFF' to the labels of all bridges in the PoE field (and not just the top one) | ||
Versie van 4 feb 2025 om 14:52
15 units; 25/01/23 fab date.
Initial Bringup / checkout
Board 001:
- Checked soldering/board as is.
- Plug in USB-C
- Check 3v3 and 5v power; check red LED
- check detection driver
- PoE powering
- Place solder bridges Vpwr, V5 to VPOE/VPOE5 in Source field
- Do not place the Vpwr/5V bridges in the PoE field - these should be better labeled: e.g. have an 'OFF' text added to them like the one just above.
- Plug in PoE ethernet; check voltages: 5V, 3v3 and Vpwr==5V
- ESP32
- Solder in the ESP32
- Unplug PoE ethernet; plug in USB;
- Check 115200 baud visibility of ESP32 (press reset if needed). Should see
ets Jul 29 2019 12:21:46
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
- Check blink app.
Improvements
- Add the word 'OFF' to the labels of all bridges in the PoE field (and not just the top one)
