PowerNodeBlue-bringup: verschil tussen versies

Versie van 4 feb 2025 om 14:53

15 units; 25/01/23 fab date.

Board 001:

Checked soldering/board as is.
Plug in USB-C
1. Check 3v3 and 5v power; check red LED
2. check detection driver
PoE powering
1. Place solder bridges Vpwr, V5 to VPOE/VPOE5 in Source field
2. Do not place the Vpwr/5V bridges in the PoE field - these should be better labeled: e.g. have an 'OFF' text added to them like the one just above.
3. Plug in PoE ethernet; check voltages: 5V, 3v3 and Vpwr==5V
ESP32
1. Solder in the ESP32
2. Unplug PoE ethernet; plug in USB;
3. Check 115200 baud visibility of ESP32 (press reset if needed). Should see
```
ets Jul 29 2019 12:21:46
```
```
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
```
4. Check blink app.

Add the word 'OFF' to the labels of all bridges in the PoE field (and not just the top one)

@@ Regel 18: / Regel 18: @@
 ## Solder in the ESP32
 ## Unplug PoE ethernet; plug in USB;
-## Check 115200 baud visibility of ESP32 (press reset if needed). Should see <pre>ets Jul 29 2019 12:21:46
+## Check 115200 baud visibility of ESP32 (press reset if needed). Should see <pre>ets Jul 29 2019 12:21:46</pre><pre>rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)</pre>
-rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
-configsip: 0, SPIWP:0xee
-clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00</pre>
 ## Check blink app.