VOIP experiment: verschil tussen versies
(→Still to do) |
|||
| (8 tussenliggende versies door dezelfde gebruiker niet weergegeven) | |||
| Regel 1: | Regel 1: | ||
[[Bestand:PhoneOld.jpg|300px|Phone]][[Bestand:SPA112.jpg| 300px |SPA112 bridge]] | [[Bestand:PhoneOld.jpg|300px|Phone]][[Bestand:SPA112.jpg| 300px |SPA112 bridge]] | ||
| + | <font size=+5>071-5690707</font> | ||
= Setup = | = Setup = | ||
| Regel 11: | Regel 12: | ||
# POTS on port 1 - number: +31715690707, 071-5690707 of 5690707 | # POTS on port 1 - number: +31715690707, 071-5690707 of 5690707 | ||
# Mangement interface op http://192.168.6.201/ | # Mangement interface op http://192.168.6.201/ | ||
| − | # 25 Hz, | + | # Configure: 25 Hz, 90 volt, sinoid for ring signal (under Voice->Region) |
| − | Not yet working - pulse based dial out | + | Not yet working - pulse based dial out (and, for now, we're not working on that - as it also means costs/billing). |
| − | = | + | = Getting the phone to work = |
Connect B and EB (Extra Bel) -- thanks to HansS for the hint ! | Connect B and EB (Extra Bel) -- thanks to HansS for the hint ! | ||
| + | |||
| + | = Still to do = | ||
| + | |||
| + | # Move SPA into patch/data enclosure | ||
| + | # Find place for phone - e.g. wall mounted, etc. | ||
| + | # <strike> Find historic wall socket</strike> (20 cents at the neighbours) | ||
| + | # Run two-pair phone cable from SPA to wall socket (or use exacting cat5 cabling) | ||
| + | # Find one of those ancient loud bells to mount on the workshop side | ||
Huidige versie van 3 mei 2025 om 19:49
071-5690707
Setup
Setup for a simple VoIP experiment:
- Account with cheapconnect
- KYC authentication (for now via Dirk's company) to get a Leiden trunk number
- SPA112 configured with the trunk
- Password to Cisco SPA112 in the usual place
- POTS on port 1 - number: +31715690707, 071-5690707 of 5690707
- Mangement interface op http://192.168.6.201/
- Configure: 25 Hz, 90 volt, sinoid for ring signal (under Voice->Region)
Not yet working - pulse based dial out (and, for now, we're not working on that - as it also means costs/billing).
Getting the phone to work
Connect B and EB (Extra Bel) -- thanks to HansS for the hint !
Still to do
- Move SPA into patch/data enclosure
- Find place for phone - e.g. wall mounted, etc.
Find historic wall socket(20 cents at the neighbours)- Run two-pair phone cable from SPA to wall socket (or use exacting cat5 cabling)
- Find one of those ancient loud bells to mount on the workshop side
