Autolock Collet: verschil tussen versies
| Regel 8: | Regel 8: | ||
[[Bestand:clarkson-2.jpg]] | [[Bestand:clarkson-2.jpg]] | ||
| − | The METRIC collects have a grove, the imperials ones do not: | + | The METRIC collects have a grove, the imperials ones do not according to http://www.model-engineer.co.uk/forums/postings.asp?th=104134 |
[[Bestand:metric.jpg]] | [[Bestand:metric.jpg]] | ||
[[Bestand:imperial.jpg]] | [[Bestand:imperial.jpg]] | ||
Versie van 10 feb 2018 om 21:50
We think that the collets are ``Clarkson S Type-small Autolock Colletss.
It is important that the end of the cutter is against the special ring/pin (labeled 4 in the picture below) - but this must not be too tight - as this will shatter de endmill.
So follow bellow instructions:
The METRIC collects have a grove, the imperials ones do not according to http://www.model-engineer.co.uk/forums/postings.asp?th=104134
