Autolock Collet: verschil tussen versies
| Regel 3: | Regel 3: | ||
It is important that the end of the cutter is against the special ring/pin (labeled 4 in the picture below) - but this must not be too tight - as this will shatter de endmill. | It is important that the end of the cutter is against the special ring/pin (labeled 4 in the picture below) - but this must not be too tight - as this will shatter de endmill. | ||
| − | So follow bellow instructions | + | '''So follow bellow instructions! |
| − | + | ''' | |
[[Bestand:clarkson-1.jpg]] | [[Bestand:clarkson-1.jpg]] | ||
[[Bestand:clarkson-2.jpg]] | [[Bestand:clarkson-2.jpg]] | ||
| + | |||
| + | = We have metric collets = | ||
The METRIC collects have a grove, the imperials ones do not according to http://www.model-engineer.co.uk/forums/postings.asp?th=104134 | The METRIC collects have a grove, the imperials ones do not according to http://www.model-engineer.co.uk/forums/postings.asp?th=104134 | ||
| − | [[Bestand:metric.jpg]] | + | [[Bestand:metric.jpg|300px]] |
| − | [[Bestand:imperial.jpg]] | + | [[Bestand:imperial.jpg|300px]] |
Versie van 12 feb 2018 om 09:57
We think that the collets are ``Clarkson S Type-small Autolock Colletss.
It is important that the end of the cutter is against the special ring/pin (labeled 4 in the picture below) - but this must not be too tight - as this will shatter de endmill.
So follow bellow instructions!
We have metric collets
The METRIC collects have a grove, the imperials ones do not according to http://www.model-engineer.co.uk/forums/postings.asp?th=104134
