Simple Box Making: verschil tussen versies
(Nieuwe pagina aangemaakt met 'Category:Docu Simple box making (notes to stop myself from re-inventing this) # Find a rectangular piece of plywood # Measure width - divide by 3 (this will...') |
|||
| Regel 4: | Regel 4: | ||
# Find a rectangular piece of plywood | # Find a rectangular piece of plywood | ||
| − | |||
# Measure width - divide by 3 (this will be the -height- of the box) | # Measure width - divide by 3 (this will be the -height- of the box) | ||
| − | |||
# Set this width on the table saw (clean with) | # Set this width on the table saw (clean with) | ||
| − | |||
# Saw length wise. So the last strip will in fact be smaller than the first two. | # Saw length wise. So the last strip will in fact be smaller than the first two. | ||
| − | |||
# Cut, from each strip; one piece the length of the box (back to back). Generally you can do this twice; for two boxes. | # Cut, from each strip; one piece the length of the box (back to back). Generally you can do this twice; for two boxes. | ||
| − | |||
# Cut from the two wider strips; two square pieces. Generally you can do this twice; for two boxes. | # Cut from the two wider strips; two square pieces. Generally you can do this twice; for two boxes. | ||
| − | |||
# Adjust the height of the tablesaw to half the tickness of the plywood. Adjust the distance to be half as wel. | # Adjust the height of the tablesaw to half the tickness of the plywood. Adjust the distance to be half as wel. | ||
| − | |||
# Make the flat cuts and the perpendicular cuts. | # Make the flat cuts and the perpendicular cuts. | ||
| + | # Finally, if needed - adjust the width of the bottom piece. | ||
| − | + | [[Bestand:box.png]] | |
Versie van 12 jan 2019 om 20:36
Simple box making (notes to stop myself from re-inventing this)
- Find a rectangular piece of plywood
- Measure width - divide by 3 (this will be the -height- of the box)
- Set this width on the table saw (clean with)
- Saw length wise. So the last strip will in fact be smaller than the first two.
- Cut, from each strip; one piece the length of the box (back to back). Generally you can do this twice; for two boxes.
- Cut from the two wider strips; two square pieces. Generally you can do this twice; for two boxes.
- Adjust the height of the tablesaw to half the tickness of the plywood. Adjust the distance to be half as wel.
- Make the flat cuts and the perpendicular cuts.
- Finally, if needed - adjust the width of the bottom piece.
