Node Tussendeur: verschil tussen versies
| Regel 13: | Regel 13: | ||
Runs on the [[Powernode 1.1|PowerNodeV11]] board. It has a separate splitter to extract a higher voltage/current (12V) for the solenoid. | Runs on the [[Powernode 1.1|PowerNodeV11]] board. It has a separate splitter to extract a higher voltage/current (12V) for the solenoid. | ||
| − | + | = History = | |
| + | |||
| + | Rebuild sometime 2016 and upgraded early 2018 with the 1.1 batch (yellow boards) | ||
| + | |||
| + | Firmware last updated 2022/2/8 with https://github.com/MakerSpaceLeiden/AccesSystem/commit/af6eefff0888c4b04d7100bf20e538bf5f61973f - to fix caching and a range of errors found by Duco when using the Arduino rather than the VisualStudio setup. | ||
Versie van 8 feb 2022 om 23:22
PoE powered Node on Ethernet voor de tussendeur in de hal.
Current IP address: 192.168.6.30 / 30:AE:A4:13:E9:3C and connected to port 2 of the patch panel
Electronics
Mosfet om een Solenoide in de deur aan te sturen. Deze draait op de 48V van de PoE.
Runs on the PowerNodeV11 board. It has a separate splitter to extract a higher voltage/current (12V) for the solenoid.
History
Rebuild sometime 2016 and upgraded early 2018 with the 1.1 batch (yellow boards)
Firmware last updated 2022/2/8 with https://github.com/MakerSpaceLeiden/AccesSystem/commit/af6eefff0888c4b04d7100bf20e538bf5f61973f - to fix caching and a range of errors found by Duco when using the Arduino rather than the VisualStudio setup.
