Collet Chuck: verschil tussen versies
Naar navigatie springen
Naar zoeken springen
Geen bewerkingssamenvatting |
|||
| Regel 14: | Regel 14: | ||
==How to use== | ==How to use== | ||
The collet chuck consists of four parts. | |||
* MT4 ER32 collet holder | |||
* Draw bar | |||
* Bushing | |||
* Nut | |||
[[Bestand:MT4ColletChuck04.jpg|800px]] | |||
In use the draw bar is threaded into the end of the ER32 holder, then fed through the spindle of the lathe (make sure to remove what ever chuck was fitted to the lathe first). The bushing is slid over the end of the draw bar and should register with the internal bore of the lathe spindle bore. Then the nut is threaded on the end to lock it all in place. | |||
Assembled it looks like this (obviously within, this photo is for demonstration purposes): | |||
[[Bestand:MT4ColletChuck03.jpg|800px]] | |||
The read of the lathe should look something like this: | |||
[[Bestand:MT4ColletChuck02.jpg|800px]] | [[Bestand:MT4ColletChuck02.jpg|800px]] | ||
==Other== | ==Other== | ||
The tool is on loan from Julia. | The tool is on loan from Julia. | ||
Versie van 14 aug 2024 16:48
Intro
We now have a collet chuck for the Metal Lathe that works with ER32 collets.
How to use
The collet chuck consists of four parts.
- MT4 ER32 collet holder
- Draw bar
- Bushing
- Nut
In use the draw bar is threaded into the end of the ER32 holder, then fed through the spindle of the lathe (make sure to remove what ever chuck was fitted to the lathe first). The bushing is slid over the end of the draw bar and should register with the internal bore of the lathe spindle bore. Then the nut is threaded on the end to lock it all in place.
Assembled it looks like this (obviously within, this photo is for demonstration purposes):
The read of the lathe should look something like this:
Other
The tool is on loan from Julia.