Autolock Collet: verschil tussen versies
Naar navigatie springen
Naar zoeken springen
Geen bewerkingssamenvatting |
Geen bewerkingssamenvatting |
||
| Regel 1: | Regel 1: | ||
We think that the collets are ``Clarkson S Type-small Autolock Collets''s. | We think that the collets are ``Clarkson S Type-small Autolock Collets''s. | ||
It is important that the end of the cutter is against the special ring/pin (labeled 4 in the picture below) - but this must not be too tight - as this will shatter de endmill. | |||
So follow bellow instructions: | |||
[[Bestand:clarkson-1.jpg]] | [[Bestand:clarkson-1.jpg]] | ||
[[Bestand:clarkson-2.jpg]] | [[Bestand:clarkson-2.jpg]] | ||
Versie van 10 feb 2018 20:29
We think that the collets are ``Clarkson S Type-small Autolock Colletss.
It is important that the end of the cutter is against the special ring/pin (labeled 4 in the picture below) - but this must not be too tight - as this will shatter de endmill.
So follow bellow instructions:
