Node Compressor: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
(Wiring and technical data)
Regel 11: Regel 11:
 
The 2 screw terminals are an Optocoupler for AC. It expects AC/230 volt. The RED led on the front is the 'AartLED'.
 
The 2 screw terminals are an Optocoupler for AC. It expects AC/230 volt. The RED led on the front is the 'AartLED'.
  
Code in [[https://github.com/dirkx/AccesSystem/blob/master/lib-arduino/ACNode/examples/CompressorNode/CompressorNode.ino]]/
+
Code in [[https://github.com/dirkx/AccesSystem/blob/master/lib-arduino/ACNode/examples/CompressorNode/CompressorNode.ino]]. Opto coupler is wired to GPIO 13, the red LED to GPIO 15 while the green LED sits across the 3v3 of the PSU.
 
+
 
Current mac address is '''3a0:20:a6:7:93:f3 '''.
 
Current mac address is '''3a0:20:a6:7:93:f3 '''.
  

Versie van 5 jan 2019 om 22:42


Compressor node/verklikker

ESP6822 gebaseerde node die kijkt of the compressor (nog) aan staat. De 'sense' pin zit aan de 'druk' schakelaar van de compressor.

< work in progress >

Wiring and technical data

The 2 screw terminals are an Optocoupler for AC. It expects AC/230 volt. The RED led on the front is the 'AartLED'.

Code in [[1]]. Opto coupler is wired to GPIO 13, the red LED to GPIO 15 while the green LED sits across the 3v3 of the PSU.

Current mac address is 3a0:20:a6:7:93:f3 .

Opto electronics

Wiring of the the opto coupler

Typical log

-- not yet in use --