CNC zero locator: verschil tussen versies
| Regel 3: | Regel 3: | ||
A bar with indents per 1 or 5cm helps you for placing the guide. The centre hole is 10mm in diameter, keeps this in mind with larger bits! | A bar with indents per 1 or 5cm helps you for placing the guide. The centre hole is 10mm in diameter, keeps this in mind with larger bits! | ||
| − | [[Bestand:CNC_zero_point_locator.jpeg|200px|thumb| | + | [[Bestand:CNC_zero_point_locator.jpeg|200px|thumb|right|alt=CNC zero point locator|CNC zero point locator|CNC zero point locator]] |
| − | [[Bestand:CNC_zero_point_locator_2.jpeg|200px|thumb| | + | [[Bestand:CNC_zero_point_locator_2.jpeg|200px|thumb|right|alt=CNC zero point locator|CNC zero point locator|CNC zero point locator]] |
= Location = | = Location = | ||
Versie van 1 nov 2023 om 11:50
For easy, but rough, estimation of your zero point you can use this jig to measure an offset from two sides of your workpiece.
A bar with indents per 1 or 5cm helps you for placing the guide. The centre hole is 10mm in diameter, keeps this in mind with larger bits!
Location
It's stored behind the PC that is controlling the CNC table.
Maintenance
The source file can be found below. Please remake the tool if you break it!
History
| Date | Description |
|---|---|
| 2023-10-29 | Tool created/cut by Jelle |
