Node DeWalt

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
DeWalt machine on off
DeWalt node/verklikker

Kleine ESP6822 node die monitored of een machine aangelaten/gebruikt wordt. Deze specifieke iteratie zit op de GroteStofAfzuiger - en rapporteert of het ding in het stopcontact zit en of ze aan staat/draait.

Planning is om ze op de compressors en afzuigers te hebben (en andere dingen die vaak aangelaten worden).

The unit is nearly identical to the NodeCompressor.

Wiring and technical data

DeWalt node/verklikker - wiring

The 4 screw terminals are AC (2x) and Optocoupler detect (2x). AC is nearest to the PSU; the inputs are 'under' the opto-coupler wires (the resistors are on the back of the board).

The fuse is a 800 mA fast (it should probably be a 50 or 100 mA slow).

Both expect AC/230 volt. The green LED is wired directly to the PSU. The blue LED has the same role as the Aart led in the other nodes. And the Red LED is swiched in software and should follow voltage detect on the Optocoupler input.

Code in [[1]].

The 3v3 on the duaghter board is wired to the ADC -- so the PSU can power the board through this pin. The VCC pin runs via an 5v->3v3 regulator on the back. This lets us re-program it (e.g. when OTA has failed) with a standard ESP 5v programming board (such as any|Witty Cloud ESP12 or similar board (Around 3 euro for a programmer and an ESP12E).

Current mac address is A0:20:A6:04:5A:45 -- the node is on wifi, so no switch port assigned. It flags as 'ESP_045A45' as its DHCP client name.

Opto electronics

Wiring of the 3 opto couplers

Typical log

  {
     "node": "dewalt",
     "machine": "dewalt",
     "maxMqtt": 1258,
     "id": "285253",
     "ip": "192.168.6.211",
     "net": "WiFi",
     "mac": "A0:20:A6:04:5A:45",
     "beat": 0,
     "approve": 0,
     "deny": 0,
     "requests": 0,
     "mqtt_reconnects": 2,
     "loop_rate": 22560.2,
     "heap_free": 27104,
     "state": "Powered - but idle",
     "powered_time": 271192,
     "running_time": 157,
     "ota": true,
     "acstate": true
  }