Jigs (wood)

Uit MakerSpace Leiden
Naar navigatie springen Naar zoeken springen
De printervriendelijke versie wordt niet langer ondersteund en kan weergavefouten bevatten. Werk uw browserbladwijzers bij en gebruik de gewone afdrukfunctie van de browser.

Catégorie:Wood This page regroups information about custom made jigs for various machines of the wood workshop.

Table Saw jigs

Rod maker (table saw lathe)

The purpose of this jig is to create straight, cylindrical rods of wood, between ~20mm and ~90mm diameter, up to 65 cm in length, i.e. longer than what you can do with the wood lathe.

Material preparation

Table saw preaparation

<translate> Warning</translate> Warning:

In order to operate the jig, it is necessary to remove the riving knife of the table saw, located behind the saw blade. Do not use the table saw with anything else than the jig while the riving knife is not mounted, there is a high risk of injury otherwise.

This can be done with a 19mm wrench.

Jig setup

Picture frame jig

Tapering jig