CNC zero locator

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken

For easy, but rough, estimation of your zero point you can use this jig to measure an offset from two sides of your workpiece.

A bar with indents per 1 or 5cm helps you for placing the guide. The centre hole is 10mm in diameter, keeps this in mind with larger bits!

It's stored behind the PC that is controlling the CNC table.

The source file can be found below. Please remake the tool if you break it!

CNC zero point locator
CNC zero point locator
CNC zero point locator
CNC zero point locator

here