NodeCompressor: verschil tussen versies
(→Wiring and technical data) |
|||
| Regel 11: | Regel 11: | ||
The 2 screw terminals are an Optocoupler for AC. It expects AC/230 volt. The RED led on the front is the 'AartLED'. | The 2 screw terminals are an Optocoupler for AC. It expects AC/230 volt. The RED led on the front is the 'AartLED'. | ||
| − | Code in [[https://github.com/dirkx/AccesSystem/blob/master/lib-arduino/ACNode/examples/CompressorNode/CompressorNode.ino]] | + | Code in [[https://github.com/dirkx/AccesSystem/blob/master/lib-arduino/ACNode/examples/CompressorNode/CompressorNode.ino]]. Opto coupler is wired to GPIO 13, the red LED to GPIO 15 while the green LED sits across the 3v3 of the PSU. |
| − | + | ||
Current mac address is '''3a0:20:a6:7:93:f3 '''. | Current mac address is '''3a0:20:a6:7:93:f3 '''. | ||
Versie van 5 jan 2019 om 23:42
ESP6822 gebaseerde node die kijkt of the compressor (nog) aan staat. De 'sense' pin zit aan de 'druk' schakelaar van de compressor.
< work in progress >
Wiring and technical data
The 2 screw terminals are an Optocoupler for AC. It expects AC/230 volt. The RED led on the front is the 'AartLED'.
Code in [[1]]. Opto coupler is wired to GPIO 13, the red LED to GPIO 15 while the green LED sits across the 3v3 of the PSU.
Current mac address is 3a0:20:a6:7:93:f3 .
Opto electronics
Typical log
-- not yet in use --
