Router Table / Tafelfrees

From MakerSpace Leiden
(Redirected from Router Table)
Jump to: navigation, search

This equipment is safety category 3:

  • Mandatory, in person, instructions.
  • Make sure you read the Wiki before asking.

This equipment is Noise Category 2:
Can be used at all hours, but in moderation.
Be considerate; if you feel you need to wear ear protection,
then only use the tool between 07:00 and 19:00.

This equipment is should be used with active dust control.
Connect the shopvac prior to use.

God save the queen! WARNING: Imperial tools have slightly different sizes than Metric ones.

Using the wrong one will often damage the bolt, nut or whatever you are working on. See this list for all the imperial tools we have.

Try not to mix them with our metric tools -- to make sure your fellow maker does not ruin their work.
Be especially careful with the close friends, such as sizes like 5/8inch and 16mm;
although the difference is 0.13mm - you will ruin (or usually just crack) a collet or similar..


Router Table.

WARNING: has an imperial collet !

The current collet takes 1/4 of an inch bits.

Be very careful with the collet sizes; a 1/4 of an inch is almost 6mm - but not quite. Putting a 6mm bit into a 1/4th of an inch collet will absolotely ruin it. And they are expensive and hard to replace (long lead team; 30-60 euro's).


Owned by HansD. See Category:OnLoan.