IKier Laser Cutter
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
Intro
We now have an ikier K1 Pro Max 70w laser engraver/cutter.
We're still learning how to use it. More info will follow.
Software
The preferred software to prepare your case engraving / cutting job is LightBurn. LightBurn is available for Linux, Mac OS and Windows. A 30 day free trial of LightBurn is available from their website..
You should do as much preparation on your project as possible on your own laptop / computer before taking your project to the Ikier K1.
Within the next month or so we'll figure out how everyone will have access to LightBurn after the 30 day trial on your personal computer expires.
Usage
Make sure the main ventilation is turned on (switch on the wall behind the big trace container) before you start using the machine.
Settings
Knowing what settings to use for a given cut of a given material ultimately comes down to trial and error. However, for a starting point, there's the Ikier_Settings page.