Desoldeerbout 80W / Desoldering Pump / Tinzuiger: verschil tussen versies
k |
k |
||
| Regel 19: | Regel 19: | ||
Key bits of use | Key bits of use | ||
| + | |||
| + | After use the iron should be cleaned by sucking 3-5 times clean. Any residual solder waste can be cleaned from the inside. | ||
= Maintenance = | = Maintenance = | ||
| Regel 29: | Regel 31: | ||
= History and Ownership = | = History and Ownership = | ||
| − | |||
| − | |||
| − | |||
Bought late 2021; owned by the space. | Bought late 2021; owned by the space. | ||
| − | |||
| − | |||
Versie van 12 okt 2021 om 18:59
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is safety category 4:
- In-person, instructions strongly advised but not mandatory.
- Reading, and following, the instructions on the Wiki is mandatory!
.. images ..
Mention location and expected use.
Risks
XX check what is in the manual XXX
Beware that you are handling molten metal. Consider wearing safetyglasses if things are likely to splatter.
XXX add something if there are glass parts or other risks
Manual / use
Manual in English and in Nederlands
Key bits of use
After use the iron should be cleaned by sucking 3-5 times clean. Any residual solder waste can be cleaned from the inside.
Maintenance
If any
Trouble Shooting
XXX
History and Ownership
Bought late 2021; owned by the space.
| Datum | Comment |
| September 2021 | Bought from Eleshop by the Makerspace. |
