Desoldeerbout 80W / Desoldering Pump / Tinzuiger

This equipment is Noise Category 3: Can be used at all hours. No limits.

This equipment is safety category 4:

• In-person, instructions strongly advised but not mandatory.
• Reading, and following, the instructions on the Wiki is mandatory!

Located at the soldering table

Risks

XX check what is in the manual XXX

Beware that you are handling molten metal. Consider wearing safetyglasses if things are likely to splatter.

XXX add something if there are glass parts or other risks

Manual / use

Manual in English and in Nederlands

Short list with the key points for usage, read the manual for the complete instructions.

• Turn on the device by pressing the red button.
• Select the temperature by pressing up/down buttons. Beware of the different between Celsius and Kelvin.
• Put the nozzle over the pin that should be cleaned.
• Pull the trigger to suck the molten solder from the pin.
• After use the gun should be cleaned by sucking clean for a few times (3-5). Also use the cleaning pins to clean the nozzle, after using those pins also suck the residual solder from the nozzle. Solder that is left in the nozzle will damage the nozzle.

Maintenance

After every usage the nozzle should be cleaned with a cleaning pin.

The glass tube should be emptied once in a while, read the manual for instructions how to do this.

Trouble Shooting

TBD

History and Ownership

Bought late 2021; owned by the space.

Datum	Comment
September 2021	Bought from Eleshop by the Makerspace.