Tapjes, Machinist: verschil tussen versies
(→See also) |
|||
| Regel 1: | Regel 1: | ||
| − | [[categorie:Small]][[categorie:Metal]][[categorie:Boren]] | + | [[categorie:Small]][[categorie:Metal]][[categorie:Boren]]{{SafetyCat3}}{{NoiseCat3}} |
| − | {{SafetyCat3}} | ||
| − | {{NoiseCat3}} | ||
[[Bestand:Tapset2.jpeg|miniatuur|Tapset]] | [[Bestand:Tapset2.jpeg|miniatuur|Tapset]] | ||
| − | |||
We keep a set metric threadcutters/"Taps" s separate from our normal [[Tapjes]] in the red/gray drawers. | We keep a set metric threadcutters/"Taps" s separate from our normal [[Tapjes]] in the red/gray drawers. | ||
Versie van 8 mei 2023 om 16:16
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We keep a set metric threadcutters/"Taps" s separate from our normal Tapjes in the red/gray drawers.
Inhoud
[verbergen]Instructions mandatory
This is for use of those that had Metal lathe and Metal router instructions only.
Instructions mandatory
Bottom drawer of the Metal lathe.
See also
Boorsnelheid RPM / drilling speed and Cutting oil
History and ownership
- Gekocht door de space: may 2023 (after earlier purchases where damaged)
