Tapjes, Machinist: verschil tussen versies
(→See also) |
|||
| Regel 3: | Regel 3: | ||
[[Bestand:Tapset2.jpeg|miniatuur|Tapset]] | [[Bestand:Tapset2.jpeg|miniatuur|Tapset]] | ||
| − | We keep a set metric threadcutters/"Taps" s separate from our normal [[Tapjes]] in the red/gray drawers. | + | We keep a set metric threadcutters/"Taps" s separate from our normal [[Tapjes Handtappenset|Tapjes]] in the red/gray drawers. |
= Instructions mandatory = | = Instructions mandatory = | ||
Versie van 25 aug 2024 om 15:02
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We keep a set metric threadcutters/"Taps" s separate from our normal Tapjes in the red/gray drawers.
Instructions mandatory
This is for use of those that had Metal lathe and Metal router instructions only.
Instructions mandatory
Bottom drawer of the Metal lathe.
See also
Boorsnelheid RPM / drilling speed and Cutting oil
History and ownership
- Gekocht door de space: may 2023 (after earlier purchases where damaged)
