Angle Vice: verschil tussen versies
(Nieuwe pagina aangemaakt met ' =Intro= We have an angle vice.') |
|||
| Regel 1: | Regel 1: | ||
=Intro= | =Intro= | ||
| − | We have an angle vice. | + | |
| + | We have an angle vice for use on the big [[Abene_VHF3_Metaalfrees_machine|Abene mill]]. | ||
| + | |||
| + | ==Where to find it?== | ||
| + | |||
| + | It is currently stored on the green metal shelving to the right of the mill, and to the left of the blue cupboard. | ||
| + | |||
| + | ==How to use it== | ||
| + | |||
| + | To mount it on the mill table will require four bolts, t-nuts and bolts. The M14 threaded set we have mounted on the wall works, but the threaded section is not quite the right length so you'll need to fill the space with something such as a strap clamp. The threads are a snug fit in the slots on the vice. | ||
| + | |||
| + | [[Bestand:AngleVice01.jpg|width=800px]] | ||
| + | |||
| + | The vice is adjustable from 0° to 90°. | ||
| + | |||
| + | Note that this is not the most rigid of setups and chatter will be a problem. Consider using a machinest jack to support things. | ||
| + | |||
| + | When working on steel angles you will run out of space on Z. This will require either extra long end mills, end mill holders, or some other creative forms of work holding. | ||
Versie van 30 aug 2024 om 19:11
Intro
We have an angle vice for use on the big Abene mill.
Where to find it?
It is currently stored on the green metal shelving to the right of the mill, and to the left of the blue cupboard.
How to use it
To mount it on the mill table will require four bolts, t-nuts and bolts. The M14 threaded set we have mounted on the wall works, but the threaded section is not quite the right length so you'll need to fill the space with something such as a strap clamp. The threads are a snug fit in the slots on the vice.
The vice is adjustable from 0° to 90°.
Note that this is not the most rigid of setups and chatter will be a problem. Consider using a machinest jack to support things.
When working on steel angles you will run out of space on Z. This will require either extra long end mills, end mill holders, or some other creative forms of work holding.
