Linear Gaugeblocks - Eindmaten: verschil tussen versies
| (3 tussenliggende versies door dezelfde gebruiker niet weergegeven) | |||
| Regel 1: | Regel 1: | ||
[[Category:Metal]][[Category:Tool]] | [[Category:Metal]][[Category:Tool]] | ||
| − | [[ | + | [[Category:Tools]][[Category:Metal working tools]][[Category:Metal lathe and mill tools]][[Category:Measuring tools]][[Category:On loan tools]] |
{{SafetyCat6}} | {{SafetyCat6}} | ||
{{NoiseCat3}} | {{NoiseCat3}} | ||
| Regel 11: | Regel 11: | ||
Only use these for measuring. Do not use them anywhere near vices, work surfaces or machines. | Only use these for measuring. Do not use them anywhere near vices, work surfaces or machines. | ||
| − | Deze zijn niet meer aanwezig. | + | Deze zijn niet meer aanwezig. |
| − | |||
| − | |||
| − | |||
Versie van 2 okt 2024 om 21:25
This equipment is safety category 6: Other equipment with no limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
Handle with care.
This is a precision tool with exact dimensions and straightness.
That means: handle it gently, don't hammer on it or use it as a crowbar and so on.
(if you need a crowbar - these are wonderful for that!)
It is very important that if you accidentally drop it or think it may be out of line
- either mark the tool very clearly...
- or report this to the mailing list...
...so that your fellow makers do not ruin their work.
Eindmaten or gauge blocks. Very accurate blocks to check dimensions. Be very gentle and careful with them - they are expensive beasts.
Only use these for measuring. Do not use them anywhere near vices, work surfaces or machines.
Deze zijn niet meer aanwezig.
