Tapjes, Machinist: verschil tussen versies
| Regel 1: | Regel 1: | ||
| − | [[categorie:Small]][[categorie:Metal | + | [[categorie:Small]][[categorie:Metal]]{{SafetyCat3}}{{NoiseCat3}} |
| − | [[Categorie:Tools]][[Categorie:Metal working tools]][[Category:Metal lathe and mill tools]] | + | [[Categorie:Tools]][[Categorie:Metal working tools]][[Category:Metal lathe and mill tools]][[Category:Drills]] |
[[Bestand:Tapset2.jpeg|miniatuur|Tapset]] | [[Bestand:Tapset2.jpeg|miniatuur|Tapset]] | ||
Versie van 6 okt 2024 om 15:34
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We keep a set metric threadcutters/"Taps" s separate from our normal Tapjes in the red/gray drawers.
Inhoud
[verbergen]Instructions mandatory
This is for use of those that had Metal lathe and Metal router instructions only.
Instructions mandatory
Bottom drawer of the Metal lathe.
See also
Boorsnelheid RPM / drilling speed and Cutting oil
History and ownership
- Gekocht door de space: may 2023 (after earlier purchases where damaged)
