Tapjes, Machinist: verschil tussen versies
| Regel 7: | Regel 7: | ||
= Instructions mandatory = | = Instructions mandatory = | ||
| − | This is for use of those that had [[Huvema HU760 Draaibank|Metal lathe]] and [[Abene | + | This is for use of those that had [[Huvema HU760 Draaibank|Metal lathe]] and [[Abene Metal Mill / Freesbank|Metal mill]] instructions '''only'''. |
= Instructions mandatory = | = Instructions mandatory = | ||
Versie van 28 okt 2024 om 22:34
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We keep a set metric threadcutters/"Taps" s separate from our normal Tapjes in the red/gray drawers.
Instructions mandatory
This is for use of those that had Metal lathe and Metal mill instructions only.
Instructions mandatory
Bottom drawer of the Metal lathe.
See also
Boorsnelheid RPM / drilling speed and Cutting oil
History and ownership
- Gekocht door de space: may 2023 (after earlier purchases where damaged)
