Tapjes, Machinist: verschil tussen versies
| Regel 7: | Regel 7: | ||
= Instructions mandatory = | = Instructions mandatory = | ||
| − | This is for use of those that had [[ | + | This is for use of those that had [[Metal Lathe / Metaal draaibank|Metal lathe]] and [[Abene Metal Mill / Freesbank|Metal mill]] instructions '''only'''. |
= Instructions mandatory = | = Instructions mandatory = | ||
| − | Bottom drawer of the [[ | + | Bottom drawer of the [[Metal Lathe / Metaal draaibank|Metal lathe]]. |
= See also = | = See also = | ||
Versie van 29 okt 2024 om 00:56
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We keep a set metric threadcutters/"Taps" s separate from our normal Tapjes in the red/gray drawers.
Inhoud
[verbergen]Instructions mandatory
This is for use of those that had Metal lathe and Metal mill instructions only.
Instructions mandatory
Bottom drawer of the Metal lathe.
See also
Boorsnelheid RPM / drilling speed and Cutting oil
History and ownership
- Gekocht door de space: may 2023 (after earlier purchases where damaged)
