Elektrische figuurzaag (Scrollsaw): verschil tussen versies
Geen bewerkingssamenvatting |
Geen bewerkingssamenvatting |
||
| Regel 1: | Regel 1: | ||
[[Category:Tools]][[Category:Metal working tools]][[Category:Wood working tools]][[Category:SafetySheet]] | [[Category:Tools]][[Category:Metal working tools]][[Category:Wood working tools]][[Category:SafetySheet]] | ||
{{SafetyCat6}} | {{SafetyCat6}} | ||
This equipment is safety category 6: Other equipment with no limits. | |||
| Regel 14: | Regel 17: | ||
[[Bestand:Elec-figuur.jpg|miniatuur]] | [[Bestand:Elec-figuur.jpg|miniatuur]] | ||
==blades== | ==blades== | ||
Blades break easily; spare ones cost around a 5 for a pack of 10 or so. | Blades break easily; spare ones cost around a 5 for a pack of 10 or so. | ||
| Regel 35: | Regel 36: | ||
If you want to be re-imbursed; keep the receipt & tell the mailing lists that you've bought them. | If you want to be re-imbursed; keep the receipt & tell the mailing lists that you've bought them. | ||
The saw blades are in a drawer in the plastic cabinet above the device. | |||
Versie van 24 jan 2025 18:20
This equipment is safety category 6: Other equipment with no limits.
This equipment is safety category 6: Other equipment with no limits.
This equipment is safety category 6: Other equipment with no limits.
This equipment is safety category 6: Other equipment with no limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
Use of protective eye wear recommended.
We have several electrical scrollsaws. One is usually sitting in the woodshop on the bench. The others are usually on top of the cupboard in the metal working area or near the toilets.
blades
Blades break easily; spare ones cost around a 5 for a pack of 10 or so.
If you need blades for them - you typically want the `figuurzaag met dwarsstift’; [Hartwijk] usually have them as to some of the local builders markets (Gamma).
One of the machines will take a normal (without pin) saw blade. I.e. the same type as the Handheld Figuurzaag Jigsaw/scrollsaw. [Hartwijk] and the local builder shops almost always have these.
You generally want the right type for wood, metal or whatever you are sawing.
You can buy a set of 5 (extra fine to rough) at the Praxis for 7 euro (brandEinhell).
If you want to be re-imbursed; keep the receipt & tell the mailing lists that you've bought them.
The saw blades are in a drawer in the plastic cabinet above the device.
change the bladesThis applies to the Einhell DKS 405:
To replace a blade: release the tension on the saw blade using the tension adjustment knob at the bottom at the back. Then, push the arm down and first pull the bottom of the blade forward, followed by the top, to remove it.
To install a saw blade: first secure the bottom, then the top, and finally adjust the tension.
If that doesn’t work, remove the left panel by unscrewing the three screws. You will then see where the saw blade should fit.
use
These machines are for wood and metal; but acrylic and similar materials work fine.
Metal use
Do not use the machine in the woodshop for metal (to avoid contaminating the wood with oil and filing; this ruining peoples lacquer). Instead take one of the other machines to the metal shop and use it there.
Also Known As
Electrische figuurzaag