Thermometer K-thermocouple: verschil tussen versies

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken
 
(13 tussenliggende versies door 2 gebruikers niet weergegeven)
Regel 1: Regel 1:
[[Categorie:Tool]][[Category:Electronics]]
+
[[Categorie:Tool]][[Category:Measuring]]
 
+
[[Category:Tools]][[Category:Metal working tools]][[Category:Welding tools]][[Category:Electronics tools]][[Category:Ceramics and Pottery tools]][[Category:Car repair tools]][[Category:Measuring tools]][[Category:Arts and crafts tools]]
 
[[Bestand:thermometer1.jpeg|miniatuur|Thermocouple meter]]
 
[[Bestand:thermometer1.jpeg|miniatuur|Thermocouple meter]]
[[Bestand:thermometer2.jpeg|miniatuur|Thermocouple meter]]
 
 
{{NoiseCat3}}
 
{{NoiseCat3}}
 
{{SafetyCat5}}
 
{{SafetyCat5}}
Regel 8: Regel 7:
 
The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens.
 
The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens.
  
See this [[media:thermometer-k.pdf|manual]] for details.
+
Read this [[media:thermometer-k.pdf|manual]] for the instructions.
 +
 
 +
Note - we're not quite sure that the low cost (but quite accurate) 30cm stick actually is able to measure the full temperature range. So do not feel guilty if it melts - do report it though (so we can order a proper one).
 +
 
 +
See also the [[FLIR camera / Warmtebeeldcamera|FLIR camera]] and [[Optical Thermometer]].
  
 
= Box content =
 
= Box content =
Regel 18: Regel 21:
  
 
= Location =
 
= Location =
 +
[[Bestand:thermometer2.jpeg|miniatuur|Thermocouple meter]]
 +
 +
3D Printer rack in wooden box - near the [[FLIR camera / Warmtebeeldcamera|FLIR camera]].
  
3D Printer rack in wooden box - near the [[FLIR camera]].
+
= History and Ownership =
  
= History =
+
Bought by the space March 2024 with 3 probes.
  
Bought by the space March 2024 with 3 probles.
+
Last battery change 2023/03/29.

Huidige versie van 22 sep 2024 om 22:53

Thermocouple meter

This equipment is Noise Category 3: Can be used at all hours. No limits.

This equipment is safety category 5: Equipment that is relatively fragile or expensive

  • In person instructions is not mandatory.
  • Reading the wiki, and following the instructions, is mandatory.

The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens.

Read this manual for the instructions.

Note - we're not quite sure that the low cost (but quite accurate) 30cm stick actually is able to measure the full temperature range. So do not feel guilty if it melts - do report it though (so we can order a proper one).

See also the FLIR camera and Optical Thermometer.

Box content

  • One meter (needs 9v battery)
  • One 30cm 'stick' probe
  • Two short wire probes
  • 2 page manual

Location

Thermocouple meter

3D Printer rack in wooden box - near the FLIR camera.

History and Ownership

Bought by the space March 2024 with 3 probes.

Last battery change 2023/03/29.