Thermometer K-thermocouple: verschil tussen versies
| (11 tussenliggende versies door 2 gebruikers niet weergegeven) | |||
| Regel 1: | Regel 1: | ||
| − | [[ | + | [[Category:Tools]][[Category:Metal working tools]][[Category:Welding tools]][[Category:Electronics tools]][[Category:Ceramics and Pottery tools]][[Category:Car repair tools]][[Category:Measuring tools]][[Category:Arts and crafts tools]] |
| − | |||
[[Bestand:thermometer1.jpeg|miniatuur|Thermocouple meter]] | [[Bestand:thermometer1.jpeg|miniatuur|Thermocouple meter]] | ||
{{NoiseCat3}} | {{NoiseCat3}} | ||
| Regel 7: | Regel 6: | ||
The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens. | The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens. | ||
| − | + | Read this [[media:thermometer-k.pdf|manual]] for the instructions. | |
| + | |||
| + | Note - we're not quite sure that the low cost (but quite accurate) 30cm stick actually is able to measure the full temperature range. So do not feel guilty if it melts - do report it though (so we can order a proper one). | ||
| + | |||
| + | See also the [[FLIR camera / Warmtebeeldcamera|FLIR camera]] and [[Optical Thermometer]]. | ||
= Box content = | = Box content = | ||
| Regel 19: | Regel 22: | ||
[[Bestand:thermometer2.jpeg|miniatuur|Thermocouple meter]] | [[Bestand:thermometer2.jpeg|miniatuur|Thermocouple meter]] | ||
| − | 3D Printer rack in wooden box - near the [[FLIR camera]]. | + | 3D Printer rack in wooden box - near the [[FLIR camera / Warmtebeeldcamera|FLIR camera]]. |
| + | |||
| + | = History and Ownership = | ||
| − | + | Bought by the space March 2024 with 3 probes. | |
| − | + | Last battery change 2023/03/29. | |
Huidige versie van 17 nov 2024 om 20:51
This equipment is Noise Category 3: Can be used at all hours. No limits.
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
The space has a K-thermocouple thermometer with several probes; including a 'long' one to stick into ovens.
Read this manual for the instructions.
Note - we're not quite sure that the low cost (but quite accurate) 30cm stick actually is able to measure the full temperature range. So do not feel guilty if it melts - do report it though (so we can order a proper one).
See also the FLIR camera and Optical Thermometer.
Box content
- One meter (needs 9v battery)
- One 30cm 'stick' probe
- Two short wire probes
- 2 page manual
Location
3D Printer rack in wooden box - near the FLIR camera.
History and Ownership
Bought by the space March 2024 with 3 probes.
Last battery change 2023/03/29.
