MT2: verschil tussen versies
| (7 tussenliggende versies door 2 gebruikers niet weergegeven) | |||
| Regel 1: | Regel 1: | ||
| − | We have various MT2 (Morse Taper 2) holders and machines. | + | [[Categorie:Tool]][[Categorie:Metal]][[Categorie:Small]][[Categorie:Wood]] |
| + | {{SafetyCat6}}{{NoiseCat3}} | ||
| + | |||
| + | We have various MT2 ([https://en.wikipedia.org/wiki/Machine_taper Morse Taper 2]) holders and machines. | ||
| + | |||
| + | |||
| + | [[Bestand:MT2TaperTooling01.jpg|thumb|MT2 tooling setup next to the lathe]] | ||
| + | [[Bestand:MT2ER25Collet01.jpg|thumb|MT2 ER25 Collet Holder]] | ||
| + | [[Bestand:MT2-MT4-01.jpg|thumb|MT2 to MT4 adapter to allow putting MT2 items to fit in the lathe chuck spindle]] | ||
| + | |||
Such as: | Such as: | ||
| − | * [[Pijp-center Tail - Stock Pipe Center]] | + | * [[Pijp-center Tail - Stock Pipe Center]] voor dikke pijpen |
| − | * [[MT2 Hand chuck]] | + | * Diverse [[MT2 Hand chuck]] |
* [[ER 25/32/40 Collets and holders]] met MT2 einde. | * [[ER 25/32/40 Collets and holders]] met MT2 einde. | ||
| − | * Diverse houders en adaptors om dingen onder een hoek vast te houden. | + | * Diverse houders en adaptors om dingen onder een hoek vast te houden. (Where are they?) |
| − | * | + | * Live centre |
| − | * Tap houders. | + | * Dead centre |
| + | * Tap houders. (Where are these stored?} | ||
| + | * 22mm drill | ||
And these can be used on several machines: | And these can be used on several machines: | ||
| − | * [Abene VHF3 Metaalfrees machine]] | + | * [[Abene VHF3 Metaalfrees machine]] |
* [[Houtdraaibank]] | * [[Houtdraaibank]] | ||
* [[Metaaldraaibank]] | * [[Metaaldraaibank]] | ||
* [[Drill press / boorkolom]] | * [[Drill press / boorkolom]] | ||
| + | |||
| + | Useful too: | ||
| + | |||
| + | * [[MT2/MT4|MT2/MT4 convertor]] | ||
Huidige versie van 31 mei 2024 om 22:11
This equipment is safety category 6: Other equipment with no limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
We have various MT2 (Morse Taper 2) holders and machines.
Such as:
- Pijp-center Tail - Stock Pipe Center voor dikke pijpen
- Diverse MT2 Hand chuck
- ER 25/32/40 Collets and holders met MT2 einde.
- Diverse houders en adaptors om dingen onder een hoek vast te houden. (Where are they?)
- Live centre
- Dead centre
- Tap houders. (Where are these stored?}
- 22mm drill
And these can be used on several machines:
Useful too:
