ER 25/32/40 Collets and holders: verschil tussen versies
| Regel 1: | Regel 1: | ||
[[Category:Tool]][[Category:Metal]][[Category:SafetySheet]] | [[Category:Tool]][[Category:Metal]][[Category:SafetySheet]] | ||
| − | {{ | + | {{SafetyCat4}} |
{{NoiseCat3}} | {{NoiseCat3}} | ||
Versie van 4 jun 2019 om 13:16
This equipment is safety category 4:
- In-person, instructions strongly advised but not mandatory.
- Reading, and following, the instructions on the Wiki is mandatory!
This equipment is Noise Category 3: Can be used at all hours. No limits.
Bestand:Er25-set
ER25 metric collet set
Set of METRIC collets -- for the ER25 holder of the Abene, Metal Lathe and Wood Lathe. Sizes 1mm - 16mm -- and each will take 1mm smaller. So actual range is 0 to 16mm. Do not use them outside this range. They will break (check the box with the boring bar for examples).
Make sure you `angle-click' the collet into the nut (do not force it straight). Have someone show you if you've not done it before -- as it is easy to get them out of shape this way -- causing vibration.
History
Bought June 2019.
