Plasma Cutter: verschil tussen versies
| Regel 21: | Regel 21: | ||
Input: 230 V~ 50 Hz<br> | Input: 230 V~ 50 Hz<br> | ||
Weight: approx. 5.2 kg<br> | Weight: approx. 5.2 kg<br> | ||
| − | |||
| − | |||
Dimensions: 341 × 113 x 237 mm<br> | Dimensions: 341 × 113 x 237 mm<br> | ||
| − | |||
Insulation class: H<br> | Insulation class: H<br> | ||
| − | |||
Duty Cycle: 35 % at 40 A (25 °C) 20 % at 40 A (40 °C)<br> | Duty Cycle: 35 % at 40 A (25 °C) 20 % at 40 A (40 °C)<br> | ||
| − | |||
‘Real’ cutting capacity: | ‘Real’ cutting capacity: | ||
0.1 mm – 12 mm (depending on the material)<br> | 0.1 mm – 12 mm (depending on the material)<br> | ||
| + | |||
| + | '''Replacement Parts/ Reserve Onderdelen''' | ||
Versie van 22 jan 2020 om 14:03
This equipment is safety category 3:
- Mandatory, in person, instructions.
- Make sure you read the Wiki before asking.
This equipment is Noise Category 3: Can be used at all hours. No limits.
The space has a small PlasmaCutter / Plasmasnijder.
We do not yet know much about it. Consult the (true) Major of the Welding area for more information.
It is a Parkside PPs40A1. manual: [[1]]
It needs a 5mm outer, G1/4 outer coupler for 8x5 tube to Euro insteeknippel to properly hook it up. The current solution is bound to come loose.
It uses around 150 Liters of air per minute. At 4.5-5 bar initial/headend pressure.
Length of the hose to the torch is about 2m.
Technical specifications from manual:
Output: 15-40 A
Input: 230 V~ 50 Hz
Weight: approx. 5.2 kg
Dimensions: 341 × 113 x 237 mm
Insulation class: H
Duty Cycle: 35 % at 40 A (25 °C) 20 % at 40 A (40 °C)
‘Real’ cutting capacity:
0.1 mm – 12 mm (depending on the material)
Replacement Parts/ Reserve Onderdelen
