ER 25/32/40 Collets and holders: verschil tussen versies
| Regel 3: | Regel 3: | ||
{{NoiseCat3}} | {{NoiseCat3}} | ||
| − | [[Bestand:Er25-set|miniatuur|ER25 metric collet set]] | + | [[Bestand:Er25-set.jpeg|miniatuur|ER25 metric collet set]] |
Set of METRIC collets -- for the ER25 holder of the Abene, Metal Lathe and Wood Lathe. Sizes 1mm - 16mm -- and each will take 1mm smaller. So actual range is 0 to 16mm. Do not use them outside this range. They will break (check the box with the boring bar for examples). | Set of METRIC collets -- for the ER25 holder of the Abene, Metal Lathe and Wood Lathe. Sizes 1mm - 16mm -- and each will take 1mm smaller. So actual range is 0 to 16mm. Do not use them outside this range. They will break (check the box with the boring bar for examples). | ||
Versie van 4 jun 2019 om 13:17
This equipment is safety category 5: Equipment that is relatively fragile or expensive
- In person instructions is not mandatory.
- Reading the wiki, and following the instructions, is mandatory.
This equipment is Noise Category 3: Can be used at all hours. No limits.
Set of METRIC collets -- for the ER25 holder of the Abene, Metal Lathe and Wood Lathe. Sizes 1mm - 16mm -- and each will take 1mm smaller. So actual range is 0 to 16mm. Do not use them outside this range. They will break (check the box with the boring bar for examples).
Make sure you `angle-click' the collet into the nut (do not force it straight). Have someone show you if you've not done it before -- as it is easy to get them out of shape this way -- causing vibration.
History
Bought June 2019.
