Megger / Insulation Meter

Uit MakerSpace Leiden
Naar navigatie springen Naar zoeken springen
De printervriendelijke versie wordt niet langer ondersteund en kan weergavefouten bevatten. Werk uw browserbladwijzers bij en gebruik de gewone afdrukfunctie van de browser.


"Megger" or Insulation meter - can be used to measure the isolation; for example of our 3 phase motors in the Metal Mitresaw, the Circular Table Saw or any of our normal 2 phase electric machines.

It works by putting 500V or a 1000V across the measuring probes and then checking, measuring, if the resistance is well in the mega ohms.

This means that, during measurement, there is a lethal, 1000V, across the probes !

So you must use well isolated test probes - and not hold these in your hand.

History

Bought by the space early 2024

This equipment is safety category 4:

  • In-person, instructions strongly advised but not mandatory.
  • Reading, and following, the instructions on the Wiki is mandatory!

This equipment is Noise Category 3: Can be used at all hours. No limits.

Handle with care - fragile ! Handle with care.
This is a precision tool with exact dimensions and straightness.
That means: handle it gently, don't hammer on it or use it as a crowbar and so on.
(if you need a crowbar - these are wonderful for that!)


It is very important that if you accidentally drop it or think it may be out of line

  • either mark the tool very clearly...
  • or report this to the mailing list...

...so that your fellow makers do not ruin their work.