ToDo
We maintain the space collectively - as an all volunteer effort.
Inhoud
Physical things
New dust control for the wood workshop: Succobus
- Tubing:
- Put short pipes on each T junction behind each machine; then the Valve, then a short pipe and then a bit of hose of the right length. Secure with hose clamps. We'll need to make a few wooden/plastic adaptors on the lathe to get the diameters right.
- Electrics:
- Run a 3 phase cable from behind the bandsaw over the wood-storage area to the Succobus box.
- Wire up the 3 phase with the slow-starter & wire the slowstart to the control box.
- Collector:
- Figure out of/how we put a thin dust collector above the separator.
- Mount this on the wall.
- Check if we need to remove the 90 degree angles/replace by 3x30 to get better flow.
- See if we need to attach the separate to the wall - and het the drum 'drop' down below it.
checkout node
- Run 3 ethernet cables to the space-door for the checkout node; and touch screen/etc.
- Terminate the loose ethernet cable and figure out where they go.
Blue Laser engraver/cutter
- Specialist work. Don' t undertake unless comfortable and capable. See [Blue_laser_engraver]
- check high voltage wiring connections to the laser tube
- it currently runs "test" firmware, check that buttons/motors function as they should
- Set max. lasertube current (2 person job for safety reasons).
- once all is OK, flash "use" firmware
- test
- non-specialist work:
- update [Blue_laser_engraver] (Add a picture)
floor
- fix holes in floor in large room (with the right kind of concrete / get it somewhat level and evenly)
- procure/find/ask shops for scraps a piece of linoleum for the small room. Same thickness, any color. About .. cm wide / .. m long. Or smaller pieces that add up. Also glue and filament (for the seams).
- put it all in place, fixing the "gutter" in front of E-table.
lights
- Hang the warmer lights in the small room (preferably before Hans returns! as he donated them.)
- We might need to get cable etc. first
recurrent
- vacuüm small room
- And maybe the larger one too (or use a broom)
- Dishes
- clean kitchen
- clean toilet
Documentation things
- Update the wiki to describe the second garbage bin processes.
- We have quite a few [[Category::Tools]] without foto's or where we use bland photos from HBM. To replace. Ideally in situ so you know where things are.
- Video of an expert (e.g. HenkD) replacing & adjusting the knifes on the planer/jointer with the special tool.
Cyber Things
- Add OpenID or similar to the CRM and push/wire this up to wordpress and the wiki.
- Find and install crosspost module on wordpress to twitter/facebook.
- See if we can do post-by-email or simpler for wordpress.