DeWalt DW60 Dust Extractor / Grote afzuiger

This equipment is safety category 6: Other equipment with no limits.

This equipment is Noise Category 1: can only be used between 07:00 and 19:00.
Wear hearing protection.

DeWalt with new filter and clear bag (feb 2020)

So really - do not leave it like this. EMPTY the green back when it is about 2/3 full. Always.

DeWalt large dust extractor / MOT

Typenr: Type DW60. DeWalt spopped making these machines in 1997 and does not support them any more. To order new filter(bag or clearbags see adresses below. In Feb 2020 the Dewalt got a new filter installed. A back-up filter and the clear plastic bags are located on the attic above the Mitre Saw.

Restrictions

The extractor can only(!) be used for plain wood, so:

1. NO laminated sheets (multiplex, triplex etc)
2. NO chipboard
3. NO furniture board
4. or anything else that contains glue or other chemicals.

DO NOT use this machine for cleaning the floor, nothing else but wood chips should be in the bin.. The wood-chips are to be used in the circular food industry !

Use

1. check if it needs to be emptied (the bin is translucent now, so that should not be too hard)
2. check that there is not a lot of buildup in the tube; or bits of wood stuck.
3. plug it in
4. control it with the on/of switch on the side

Post Use

1. check that there is not a lot of buildup in the tube; or bits of wood stuck.
2. unplug it
3. if 2/3rd full - disconnect the bin and close it properly so the content cannot get contaminated. Inform the mailing list that a full bin is ready for collection.

deWalt monitor

There is a small NodeDeWalt Wifi monitor attached to the deWalt machine; much the same model as on the GrotePersluchtCompresssor and KleinePersluchtCompressor. It records if the machine is (left) on running or left plugged in during the night when there is no one.

Cleaning

Empty the bag once it is about 2/3 full. Any more and it'll be a total mess (see photo). And as the engine will now spin in the dust - you may well smoldering chips & and an airflow. Not a fun situation.

Tie the gray binliner inside close before lifting it out.

Once it is empty - put a new gray binliner inside the green bag.

Spare Parts

You can find the spare parts (Filter bag and Clear bags) in a clear plastic bin (picture will follow) on the attic above the Mitre Saw. The Clear bags are alreasy there, extra filter bags wil follow.

Purchage Clear Bags: www.plasticzak.nl