POESP-board 1.0

Uit MakerSpace Leiden
Ga naar: navigatie, zoeken


Assembled POESP 1.0

Overview

The POESP, for PoE-ESP, is a ESP32 breakout board with LAN and PoE. Please understand well this device is NOT insulated from the PoE, so use only in suitably insulated setups. DO note the "known problems". There is an usb interface for loading the firmware and debugging, be aware the ground of this interface might be at +48V from PE (or worse) as well ! So use a well-insulated laptop and/or do not use when powered by PoE. Stepdown from 48V PoE to 3v3 is done in two steps, the intermediate voltage can be set at any voltage between 5 and 24V.

This design and formfactor is abandoned by me, there might be an improved 2.0 in the future (but please do not hold your breath .. :-)

There were about 10 prototypes assembled. There are no PCB's available, but the pastastencil is @ Makerspace Leiden.

Main components:

Default SMD size is 0603.

GPIO =

GPIO Gebruik Notes
0 INT BOOT switch, high/Hz during normal boot; pulled low for bootloader
1 TX UART / USB bridge en edge connector
2 - vrij, op edge connector
3 RX UART / USB bridge en edge connector
4 - vrij, op edge connector
5 - vrij, op edge connector
6 SCK -
7 SD0 -
8 SD1 -
9 SD2 -
10 SD3 -
11 CMD -
12 - vrij, op edge connector
13 - vrij, op edge connector
14 - vrij, op edge connector
15 - vrij, op edge connector
16 - vrij, op edge connector
17 - -
18 MDIO Ethernet LAN
19 TXD0 Ethernet LAN
21 TXEN Ethernet LAN
22 TXD1 Ethernet LAN
23 MDC Ethernet LAN
25 RXD0 Ethernet LAN
26 RXD1 Ethernet LAN
27 CRS Ethernet LAN
32 - vrij, op edge connector
34 - vrij, op edge connector, input ONLY
35 - vrij, op edge connector, input ONLY
36 SVP vrij, op edge connector, input ONLY
39 SVN vrij, op edge connector, input ONLY

Files

Sources of information used

About connecting the ethernet phy to the ESP.

Suppliers

  • Boards & stencil: Elecrow
  • ESP32: AliExpress
  • Other: Mouser

Known problems

  • Not insulated. Groundloops during debugging easily fry the cp2102. Possible electrical safety issues.
  • Rx/Tx leds do not work, fixing this requires programming the CP2102.
  • The inter stage capacitors between prim. and sec. step down are too small. When the intermediate voltage is used, add an extra capacitor > 47 uF on the breakout board. Or place a larger capacity at a lower voltage if lower intermediate voltages, e.g. up to only 12V are required.
  • The CP2102 USB interface has a tendency to release smoke due to its VBUS pin beïng pulled up to 5V by the USB connection while there is no 3V3 power supply available. So only connect USB while there is already PoE available and the power LED is on. Never short 3v3 while connected to USB.