Pipe Clamps
This equipment is safety category 6: Other equipment with no limits.
This equipment is Noise Category 3: Can be used at all hours. No limits.
Wiki Pipe Clamps | March 2023 | Work in progress
Purpose
This type of pipes is particularly useful to glue up panels and/or very long pieces. The clamping capacity is about 100cm and can be extended to reach 2m.
Panel glue-up
To glue up a panel, lay the clamps on a flat surface, and place the pieces of wood you want to glue. If you are not planning on retrimming the sides of your panel afterwards, it is a good idea to place sacrificial stripes of wood between the clamp heads and your wood pieces. This has a double advantage:
- Prevent the clamp heads to dent your wood
- Distribute the clamping pressure more evenly
It is recommended to add some clamps from the top to even out the pressure forces. If the joints between the pieces are not exactly 90deg, it is a good idea to to add some transversal pieces with clamps to keep the panel flat.
Due to the way the pipes have a been manufactured, they have a black appearance that can leave some black spots on your panel. It is therefore advised to lay some tape on the pipes to prevent this.
Increase the clamping pressure evenly between all clamps and wait a bit before tightening some more.
If one clamp is blocked, you can gently use a pair of pliers (works better if you press on the bottom).
Clamping long pieces
If you need to clamp something longer than 100 cm, you can combine two clamps together to reach around 2m of clamping capacity. This is done by removing one end of the clamp (make sure you keep the plastic cap that go on the threads) and joining two clamps using plumbing fittings (stored above the clamp storage shelf).
Storage
Together with the other clamps on the clamps rack.
Ownership & History
On loan from Valère since March 2023
